M88MB6000  -  DDR3 Memory Buffer (MB)

M88MB6000 is a Load Reduced DIMM (LRDIMM) Memory Buffer (MB) that supports DDR3 SDRAM main memory. The MB allows buffering of memory traffic to support large memory capacities. Unlike DDR3 Register Buffer (SSTE32882), which only buffers Command, Address, Control and Clock, the MB also buffers the Data (DQ) interface between the Memory Controller and the DRAM components, and has extra features such as ODT processing, rank multiplication, address mirroring, control registers accessible over SMBus, and advanced test and calibration capabilities, etc. As the data electrical load is reduced for the Memory Controller interface, the system can now support more DIMMs per channel at a faster speed and higher density. All memory control for the DRAM resides in the host including memory request initiation, timing, scrubbing, sparing, and power management. The MB interface is responsible for memory requests to and from the local DIMM.

LRDIMM provides a high memory bandwidth, large capacity channel solution for DDR3 main memory systems. LRDIMM uses commodity DRAMs isolated from the channel behind the MB on the DIMM. The supported capacity exceeds 144 devices per channel (depending on channel and individual system design) and total memory capacity scales with DRAM bit density.


Fully compliant with JEDEC DDR3 Memory Buffer specification

Speed up to DDR3-2133, DDR3L-1866 and DDR3U-1600

Registering and 1:2 redriving DDR3 command, address and parts of control buses

Bidirectional retiming and 1:1 redriving of DDR3 data (DQ) signals

Regeneration of data strobe (DQS) signals from input clock

Generating clocks for DRAMs with a PVT stable phase relation to the input clock and redriven command, address and control signals

Octal physical ranks supported

x4 and x8 DRAM devices supported

SMBus for read/write access to control registers

On-die temperature sensor, accessible over SMBus

Capability to supply reference voltage source for DRAMs

Support for personality bytes

Ultra Low power consumption

1.5V, 1.35V and 1.25V VDD

Green package: 588-ball FBGA

Command/Address Processing

Control word write procedure
Parity checking on command/address (CA) signals
Input bus termination (IBT) of the CA signals
CKE power management and clock stopped power-down mode
Dual frequency operation
Soft CKE mode
Refresh stagger supported
Re-generation of ODT for DRAM interface
Rank multiplication modes
Address/command/control net pre-launch and post-launch
4 independent CKE outputs for DRAM
8 independent chip select (CS) outputs for DRAM
Normal (300-1066MHz) and test mode (70-300MHz) frequencies
Programmable driver characteristics for DRAM interface
Weak drive mode of CA signals to save power
DRAM address inversion and MRS 3T timing mode

Data Processing

One bidirectional data and data strobe DRAM interface
One bidirectional data and data strobe memory controller interface
72 data and 18 differential data strobe signals
FIFOs for decoupling controller and DRAM interface time domains
Two timing modes for controller interface: minimum latency and minimum skew
Standard DDR3 DRAM requirements for the controller interface I/Os
Optimized low power I/Os for the DRAM interface
Write leveling support for the controller interface
On-chip calibration engine for DRAM interface read/write leveling and DQ/DQS relation

DFx Features

Transparent mode
Memory BIST
Voltage margin test
Error injection

High-performance DDR3 servers


Storage systems

Networking equipment

High-end desktop computers

© 2006 – 2018 Montage Technology. All rights reserved. 沪公网安备 31010402004818号, 沪ICP备18002431号